| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni 6+ - no output on 12M/10M |
| From: | "N4PY2" <n4py2@earthlink.net> |
| Reply-to: | N4PY2 <n4py2@earthlink.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 27 Nov 2010 12:35:00 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
I would look into the low pass filter board relays that switch in the low
pass filters.
Carl Moreschi N4PY 121 Little Bell Drive Hays, NC 28635 www.n4py.com----- Original Message ----- From: "Barry N1EU" <barry.n1eu@gmail.com> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Sent: Saturday, November 27, 2010 11:59 AM Subject: [TenTec] Omni 6+ - no output on 12M/10M My Omni 6+ suddenly has zero power output on 12M/10M tested into a dummy load - all other bands fine. Can someone point me in the direction of possible faults? Tnx/73, Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.comhttp://lists.contesting.com/mailman/listinfo/tentec |
| Previous by Date: | Re: [TenTec] Omni 6+ - no output on 12M/10M and omni 6+/ power issue, Dr. Gerald N. Johnson |
|---|---|
| Next by Date: | Re: [TenTec] omni 6+/ power issue, CSM(r) Gary Huber |
| Previous by Thread: | Re: [TenTec] Omni 6+ - no output on 12M/10M and omni 6+/ power issue, Dr. Gerald N. Johnson |
| Next by Thread: | [TenTec] Looking for paragon Ii, Mike Bryce |
| Indexes: | [Date] [Thread] [Top] [All Lists] |