| To: | vinsantis@sbcglobal.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] installing ladder line |
| From: | Stuart Rohre <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 08 Nov 2010 18:05:12 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
Vince, it is better to do a curved bend, but you can transition 90
degrees with such a curve. If you meant a sharp 90 degree angle in the
line, I would not do that, as you would encourage the line to radiate.
-Stuart K5KVH |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Scout S-Meter Fail, Stuart Rohre |
|---|---|
| Next by Date: | Re: [TenTec] installing ladder line, Stuart Rohre |
| Previous by Thread: | Re: [TenTec] installing ladder line, Dr. Gerald N. Johnson |
| Next by Thread: | Re: [TenTec] installing ladder line, Rick - NJ0IP / DJ0IP |
| Indexes: | [Date] [Thread] [Top] [All Lists] |