TenTec
[Top] [All Lists]

Re: [TenTec] New Firmware

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] New Firmware
From: "Ron Castro" <ronc@sonic.net>
Reply-to: Ron Castro <ronc@sonic.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 4 Mar 2009 19:34:02 -0800
List-post: <mailto:tentec@contesting.com>
I just checked on RTTY and could no reproduce that problem. S-meter operates as in other modes, but I have noticed that when tuning, the S-meter freezes along with the sweep and will not change until you stop tuning.

I also just ran a test with a signal generator trying to recreate the 'red screen' problem with a strong signal but was not able to with signals up to 0 dBm. It must be caused by something else.

        Ron N6IE
     www.N6IE.com

----- Original Message ----- From: "Kim Elmore" <cw_de_n5op@sbcglobal.net> To: "Linwood Davis" <linbdavis@earthlink.net>; "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, March 04, 2009 7:07 PM
Subject: Re: [TenTec] New Firmware


Thanks, Lin

You're the second person to confirm this. I'm not a big RTTY guy -- I
do it on occasion because it's novel. That and the cats like the
sound (I used to have cats that used to really go nuts over the TOR
modes). I simply noticed some odd behavior in the AGC and wanted to
make sure I wasn't doing anything really stoopud.

73,

Kim N5OP

At 08:57 PM 3/4/2009, you wrote:

Hi Kim,

I just checked on this and found the same behavior as you describe.

Lin
WB1AIW

-----Original Message-----
>From: Kim Elmore <cw_de_n5op@sbcglobal.net>
>Sent: Mar 3, 2009 10:32 PM
>To: Tentec Contesting List <tentec@contesting.com>
>Subject: [TenTec] New Firmware
>
>Concerning RF AGC behavior in FSK mode:
>
>I just performed the "battery fail" master reset to insure that I had
>a clean slate and I still see the atypical behavior of the S-meter
>with RF AGC in FSK mode. It's as if the AGC is preset to a "medium"
>or "fast" and none of the setting I enter (including hang time) are
>effective. However, when I am in the menu, the settings do seem to
>have a effect. Once I exit the menu, however, my settings and the
>setting of the AGC are immaterial.
>
>Can anyone else verify this?
>
>Kim Elmore, N5OP
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



<Prev in Thread] Current Thread [Next in Thread>