I have noticed that the levels between the AF and RF AGC's are quite
different. The AF is very low compared to RF.
Ron Castro
Chief Technical Officer
Results Radio, LLC
N6IE
www.N6IE.com
----- Original Message -----
From: "Peter Frenning [OZ1PIF]" <peter@frenning.dk>
To: "Linwood Davis" <linbdavis@earthlink.net>; "Discussion of Ten-Tec
Equipment" <tentec@contesting.com>
Sent: Friday, February 27, 2009 12:49 PM
Subject: Re: [TenTec] 041 firmware rev
Linwood Davis skrev:
2.041 Users,
Set O2 for AF AGC.
Then try setting the AGC to SLOW or PROG, then go into the RX menu and
turn the decay rate to less 6dB/s.
I found that severe distortion occurs.
Further, a decay rate of 6 and 7 dB/s causes the decay rate to go to 0;
it won't ever decay.
Does this occur when you folks try it?
Lin
WB1AIW
Not here Lin, behaves exactly as expected under the conditions
described....
I'm happy so far :-)
--
Vy 73 de OZ1PIF/5Q2M, Peter
** CW: Who? Me? You must be joking!! **
email: peter(no-spam-filler)@frenning.dk
http://www.frenning.dk/oz1pif.htm
Ph. +45 4619 3239
Snailmail:
Peter Frenning
Ternevej 23
DK-4130 Viby Sj.
Denmark
***********************************
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--
I am using the free version of SPAMfighter.
We are a community of 6 million users fighting spam.
SPAMfighter has removed 302 of my spam emails to date.
Get the free SPAMfighter here: http://www.spamfighter.com/len
The Professional version does not have this message
|