Yes...I saw that yesterday when I was testing the speech processor in
"flame-thrower" mode. Turning the sweep on and off fixed the problem for me
also.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "Dennis Duffin" <duffind@verizon.net>
To: <tentec@contesting.com>
Sent: Friday, February 27, 2009 11:55 AM
Subject: Re: [TenTec] 041 firmware rev
I have noticed a couple of times after the rig has been on for some
time, the scope turns all red (signal indicators are still white) and
then lines start running from top to bottom. First time, I did a master
reset and it went away. This past time I simply turned off the sweep
and turned it back on and it was normal again. Anyone experienced this
yet??
Dennis W5UV
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--
I am using the free version of SPAMfighter.
We are a community of 6 million users fighting spam.
SPAMfighter has removed 302 of my spam emails to date.
Get the free SPAMfighter here: http://www.spamfighter.com/len
The Professional version does not have this message
|