| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Orion display |
| From: | Stuart Rohre <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 18 Feb 2009 18:10:38 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
Ralph, if there are any cables to the display, try unplugging and
plugging them back in to clean contacts.
When the caps were replaced, are you sure all the solder joints were top quality? Sometimes it is easy to miss that; and I use a high intensity light and lighted magnifier to inspect my repair work for that reason. Good Luck, Stuart Rohre K5KVH |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Orion display, Ralph Matheny |
|---|---|
| Next by Date: | [TenTec] (no subject), Jim |
| Previous by Thread: | Re: [TenTec] Orion display, Ralph Matheny |
| Next by Thread: | Re: [TenTec] Orion display, rfulco |
| Indexes: | [Date] [Thread] [Top] [All Lists] |