I just went through this with my Orion 1. Initially, the display was a
little dark in the upper left corner. Then, the display pulsed/flickered
and the radio never came on: the display simply pulsed/flickered.
I changed C6/C7 on the DC distribution board but that did not correct the
problem. Then, I noticed that C9 was slightly bulging at the top; replaced
that ( $1.29 at Radio Shack) and the problem was corrected. Cheap fix.
Warning: removing any of the electrolytics on this board is a challenge.
Mike
W8TRN
----- Original Message -----
From: "Dave Heil" <k8mn@frontiernet.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, February 18, 2009 9:57 AM
Subject: Re: [TenTec] Orion display
Ralph Matheny wrote:
I wonder if anybody has successfully changed the display in an Orion in
the field. My display is getting pretty bad (lines, dark places) and I
am
going to nhave to give in and make a fix. I hate to ship it back to TT
and pay the extra if I can do it here....I'm a pretty good
fixer-upper......
Comments and pitfalls???
Ralph Matheny
K8RYU
207 Gibbons Place
Marietta Ohio 45750
mathenyr@marietta.edu
There's a very good likelihood that it isn't the display but the
electrolytic caps on the little voltage regulator board. If you don't
like the idea of changing the caps, T-T has the populated boards for not
much more than $40.
73,
Dave K8MN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|