Just out of curiosity, Dick, was that the C6 capacitor that failed?
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "Dick Williams" <k8ztt@mho.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, June 26, 2008 2:40 PM
Subject: Re: [TenTec] Orion II A9 Board Failure...Again!
> Well, my O II quit right before a contest weekend that I had hoped to pick
> up a few new ones. Called Ten Tec and upon describing the symptoms, was
> told it was most likely two capacitors on the power supply borad and they
> would send me a couple in the mail.
>
> Problem was that I wanted to use the radio; simple answer was to drive to
> Radio Shack and purchase a couple of 470uf 35WV ones. When I tore into
> the O II and found the A9 board, it was obvious that one of the caps had
> failed. Replaced it with the one from Radio Shack and I was back in
> business.
>
> That was about 4 months ago and though I have received the new ones from
> Ten
> Tec, I have not bothered to replace the Radio Shack one or the other
> "original" one that is prone to failure. If and when one of these fails,
> I
> will replace both with the new ones from Ten Tec.
>
> In any case, if there is a Radio Shack near you, there is no need to be
> down
> more than drive time plus about 20 mins to replace the bad cap.
>
> Dick K8ZTT
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|