TenTec
[Top] [All Lists]

Re: [TenTec] Orion II A9 Board Failure...Again!

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion II A9 Board Failure...Again!
From: "Dick Williams" <k8ztt@mho.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 26 Jun 2008 15:40:27 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Well, my O II quit right before a contest weekend that I had hoped to pick 
up a few new ones.  Called Ten Tec and upon describing the symptoms, was 
told it was most likely two capacitors on the power supply borad and they 
would send me a couple in the mail.

Problem was that I wanted to use the radio;  simple answer was to drive to 
Radio Shack and purchase a couple of 470uf  35WV ones.   When I tore into 
the O II and found the A9 board, it was obvious that one of the caps had 
failed.  Replaced it with the one from Radio Shack and I was back in 
business.

That was about 4 months ago and though I have received the new ones from Ten 
Tec, I have not bothered to replace the Radio Shack one or the other 
"original" one that is prone to failure.   If and when one of these fails, I 
will  replace both with the new ones from Ten Tec.

In any case, if there is a Radio Shack near you, there is no need to be down 
more than drive time plus about 20 mins to replace the bad cap.

Dick K8ZTT 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>