Posting to these three lists in hopes that a homebrewer / tinkerer
type might be interested.
I have two of the following Hammond heavy duty, 19-inch desktop racks,
each 6U height, never used. Couple scratches on the underside surface
where I slid them on another surface, otherwise new cond. These are
very well made, study, with adjustable front/rear mounts. Compatible
with other Hammond bits such as casters, hinged/keyed access door,
etc.
Included are 10 blank panels (heavy ga. aluminum), new, in various
U-sizes, and a bunch of front-panel mounting hardware (32 clips, 29
screws with nylon washers...)
PRODUCT GENERAL FEATURES:
http://www.hammondmfg.com/rackrchs.htm
(the image shown on the page happens to be the same size/height as these ones).
PRODUCT DETAILED DIMENSIONS:
http://www.hammondmfg.com/pdf/RCHS1901017.pdf
Cost of all this a few months ago was around $800 ($250 per rack, plus
panels and shipping). Shipping is likely more now. Each rack is
about 30 lbs.
I will sell everything for $300. You pick up in Kittery, Maine area.
Photos of the actual units are available upon request.
--Andrew, NV1B
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|