Try common "lamp cord"... the two conductor parallel kind. depending upon
gage of the conductors, you will find them very close to 75 Ohm.
Obviously not a high power solution.
73,
Gary - AB9M
www.csm-gh.com
--------------------------------------------------
From: "Steve Hunt" <steve@karinya.net>
Sent: Wednesday, June 11, 2008 3:35 AM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: [TenTec] OT 75 Ohm twin feeder
> I've been experimenting with ways of constructing 75 Ohm twin feeder for
> a Hexbeam application - it's now very difficult to get the heavier duty
> commercial cable - the only manufacturer in UK has ceased production.
>
> On my website I recommend using 50 Ohm coax for the Hexbeam band
> interconnects, but folk who opt to use the higher power handling RG213
> sometimes have difficulty making off the ends. Twin feeder would be
> easier to use, and as long as its characteristic impedance was less
> than about 80 Ohms it would work fine.
>
> It turns out that 2 lengths of RG58 taped side by side produce the right
> value Zo, using the braids as "fat" conductors spaced by the PVC
> jacket. In a final version I would probably hold them together using
> heatshrink tubing. I only need short lengths - maximum 24" - so losses
> are not likely to be an issue.
>
> I wondered what's a good way of estimating the power handling capability
> of this arrangement. What's likely to be the limiting factor - the
> voltage breakdown through the PVC ?
>
> Grateful for any views.
>
> Steve, G3TXQ
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|