Folks, if we are going to discuss this, lets get some data either in dBw or
uV values. Otherwise, what's an S-9 signal and a S-2 signal?
Frankly, with >60 dB isolation, a signal on the inactive input won't be
heard above atmospheric noise on the active input.
73
Bob, K4TAX
----- Original Message -----
From: "Merv Schweigert" <k9fd@flex.com>
To: "Carl Moreschi" <n4py@arrl.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Monday, January 07, 2008 10:25 PM
Subject: Re: [TenTec] Need help from an Orion owner......
>
I just listened on my Orion. I found an S9 CW station on antenna 1.
Switching to antenna 2, I could just barely hear him at S1. This is
great
isolation. So the real question is how many S units lower are you
hearing
the station with antenna 2 selected. Mine is showing greater than 8 S
units
lower.
Carl Moreschi N4PY
I realize its not a Ten Tec but if you are interested in a comparison,
Ft-1000D signal 30 db over 9, just audible with ant 2 selected.
thats more what I consider isolation. YMMV
My Omni 6 with S9 signal can just hear the ant 2 selected,
no meter movement.
I sure dont need a radio that can hear off the other antenna port.
Merv K9FD/Kh6
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|