I did the ram reset by holding in the vfoB lock button while powering up,
then did the master reset by doing the vfoa/antenna1 button. Is this the
wrong way?
73 de Neal k3nc
On 9/9/06, Toby Pennington <toby423@earthlink.net> wrote:
>
>
> Hold user 2 down while powering up the rig and reinstall the
> firmware. Toby
> W4CAK
>
> ----- Original Message -----
> From: <K4IA@aol.com>
> To: <tentec@contesting.com>
> Cc: <ditsnbits@tentec.com>
> Sent: Friday, September 08, 2006 11:45 PM
> Subject: [TenTec] Blue screen of death Orion 1
>
>
> > After playing with the new software and deciding it sounded "off"
> (clicking
> > in the headphones, fuzzy CW note, too much noise), I decided to do a RAM
> reset
> > = ON + VFOB LOCK.
> >
> > The radio did its master reset but after starting to boot up the screen
> went
> > blank - dead - nada - nothing works - no sound - no nothing. I have
> tried
> > another RAM reset and a Master Reset but still get the blank screen.
> >
> > Ideas?
> >
> > k4ia
> > Craig "Buck"
> > Fredericksburg, Virginia USA
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|