> I reloaded 2.037J and did a master reset. I still noticed
> the AGC is way fast compared to earlier versions, and may be
> the source of reports of 'raspiness' in the receive audio.
I noticed this also.
After first loading 2.037 yesterday, I thought there was a bug, and that AGC
was OFF in all settings. I finally went in to the SLOW setting and dropped
the decay speed to the 1-5 range. Once I fiddled with that a bit, the
"fast" slow AGC slowed down, AND I could tell there was a difference between
the other (MED, FAST, OFF) etc. settings
This happened twice, the second time after the radio had been sitting idle
but powered on for several hours.
If there's a bug lurking in there somewhere, I have not been able to get it
to reproduce again. I did not observe the same behavior on the v2 Orion
with 2.059-- only on the Orion II at 2.037.
I agree with you, that it helps to add just a little AGC hang.
Grant/NQ5T
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|