TenTec
[Top] [All Lists]

Re: [TenTec] Sidetone Level with 2.037j

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Sidetone Level with 2.037j
From: "Bob Cunnings" <bob.cunnings@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 9 Sep 2006 10:06:47 -0600
List-post: <mailto:tentec@contesting.com>
Yes. I'm a CW op, and if I set the sidetone level so that the "spot"
tone has the level I like, then the sidetone when keying is much too
low, down 10 dB or so from the "spot" level. This is a change from
previous versions and needs to be fixed IMHO. I reported my
observation to ditsnbits.

Bob NW8L

On 9/8/06, Klaus Heintzenberg <dj6rx@t-online.de> wrote:
> O2 S/N 02C10436
>
> On my O2 with firmware 2.037j the sidetone level appears to be
> too weak for my taste.
> Used to have the sidetone level set to 50% for the front panel
> headphone connector. This is now much to weak. Even cranking it up to
> 100% does not help much.
> Now I must use the rear speaker output to reach a comfortable level.
> Do others notice the same?
>
> 73, Klaus
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>