At 03:48 AM 6/18/2006, F.G.Robertson wrote:
Hi, our radio club has an Omni6+ (upgraded Omni6) as its main HF
transceiver. We have a couple of problems with it and would much
appreciate some advice.
2) When receiving strong CW signals, say s9+20 or 30, the CW
characters become choppy and distorted, although the tone is
fine. Switching in the RF attenuator fixes this except on very
strong signals. I haven't heard this mentioned before so I assume
it's a fault on our radio, either an alignment or component failure.
Fraser,
It sounds like the noise blanker is engaged. Turn off the noise
blanker by turning the knob fully counter clockwise.
Good luck..de John/K4WJ
|