In a message dated 6/17/2006 9:31:07 P.M. Pacific Daylight Time,
kbraunius@gmail.com writes:
How do some of you on the list mount Airpax breakers in a power line between
p/s and radio? I'm planning on putting mine in a small metal box. Do you
attach spade connectors to your power line and slip onto breaker, or solder
directly to the breaker? If soldering, what kind of mechanical connection
do you start with?
Thanks,
Kirk
AI4PZ
_______________________________________________
well I get my power from a power pole strip and then solder the wires to the
airpax breaker and them put them in a clear plastick container that a roll
of electricians tape came in and use wide clear packing tape to hold the lid
on.. its what I had handy, and it works.. I drilled a hole in the side wall to
screw the switch mount to.
been about 6 months and working fine, I was going to get a nice box for it,
but... what the hey, its fine
tom N6AJR
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|