Great q multiplier circuit on the HBR site. In fact, the HBR site is
absolutely facinating. http://www.qsl.net/k5bcq/HBR/hbr.htm
-------Original Message-------
From: Bwana Bob
Date: 12/28/05 20:01:35
To: Discussion of Ten-Tec Equipment
Cc: kg6tt@arrl.net
Subject: Re: [TenTec] 1254 Q-Multiplier... Yes. Add a signal strenght
metertoo and replace those 1N4148s in the 2nd Mixer!
That's exactly what I was doing today: looking at the QF-1 schematic to
see if it could be done with FET's. That Q-multiplier from the 1958
Handbook sounds like the same one that I built from the 1964 Handbook. I
don't have the schematic anymore, but I still have the parts in the junk
box. Anybody have a 1958 or 1964 Handbook?
73,
Bob WB2VUF
Ralph Matheny wrote:
There is a one-transistor Q mult circuit back in the 1958!!!!! ARRL
handbook I think. I'm not sure how well it worked, and as I remember
it was intended to be a "notch" but wold also make a peak one way or
another. A drawing of the ole Heath QF-1 should give a good idea of
a tube-type circuit, which could be "transposed" to a FET with ease.
If nobody has a a QF-1 book, I have a unit and could perhaps make a
sketch of the circuit from it.
I agree---the little Rx works dern good.
Ralph Matheny
K8RYU
207 Gibbons Place
Marietta Ohio 45750
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec