Well every mic has a different output--that's what the mic gain
pot is for. My hand mic runs about 10 o'clock. I built a mic
using a d-104 case and a electrat element form a junk telephone
and the output was so high with the gain set to minimum I was
flat topping and had to add a attenuator in the base. I'm going a
different way though as the quality of the element is very poor
according to my friends.
Now for the question of the day. Many of you are referring to
V1.08. Mine has 1.07 and the web site says that 1.07 is the
current version. Can anyone explain. Are the recent ones coming
with 1.08 but it not released to the web site?
Jim K4CGY
--- RaySoifer@cs.com wrote:
> Reed,
>
> My Argo V, also v1.08, must have a little more audio gain than
> yours, or else
> I just talk louder, so the numbers are a little different, but
> I also notice
> that the 706 desk mike has lower output than the hand mike.
> With the hand
> mike, my audio gain is normally set around 10 o'clock, and with
> the desk mike
> it's around 2 o'clock. I haven't tried taking the foam off.
>
> Another problem I noticed is that the desk mike is more
> susceptible to
> picking up RF in the shack than the hand mike. Anyone else
> notice that?
>
> 73,
>
> Ray W2RS
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
__________________________________
Yahoo! for Good - Make a difference this year.
http://brand.yahoo.com/cybergivingweek2005/
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|