Re: [TenTec] argonuat 516 mike

[Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>]

The placement or position of the carrier on the slope of the SSB filter will 
greatly affect the low frequency response and in addition, it can affect the 
carrier suppression too.
Check the manual for the specific radio and be sure to use a very accurate 
frequency counter.  Adjustment needs to be absolute within 10 Hz or better. 
While you are in there, check all of the BFO oscillators.
73
Bob, K4TAX


----- Original Message ----- 
From: "Toby Pennington" <toby423@earthlink.net>
To: <roncasa@verizon.net>; "Discussion of Ten-Tec Equipment" 
<tentec@contesting.com>
Sent: Saturday, December 17, 2005 5:26 PM
Subject: Re: [TenTec] argonuat 516 mike


> I have been using the 705 mike but I get reports of high pitched audio.  I
> think the 706 is a bassier mike from what I have heard,   and I may try 
> one
> of those. Someone said the carrier osc. might need to be adjusted.
>
>
> ----- Original Message ----- 
> From: "ron" <roncasa@verizon.net>
> To: "Toby Pennington" <toby423@earthlink.net>; "Discussion of Ten-Tec
> Equipment" <tentec@contesting.com>
> Sent: Saturday, December 17, 2005 5:39 PM
> Subject: Re: [TenTec] argonuat 516 mike
>
>
> > I use their table mike, the 706 (not the rig - heh heh).
> > I like the hand mike due to needing to be a "close talker" for mike
> > setting.
> > My main mode of operation is CW with some PSK. Buying a Heil or
> > something will never become an option. Buying a keyer from Idiom press
> has.
> > (smile)
> > Ron wb1hga
> >
> > Toby Pennington wrote:
> > > Ron, What mike do you use on the Argo?   Toby  W4CAK
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec