Mike,
I used my Omni-VI on several previous field days and I always had some
problems with it. I called Ten Tec technical support and the gentleman
there told me the OMN-VI should not be operated on a battery as the voltage
was too low. That's why I keep my Omni-VI in the shack and use my K2/100
on field day, which does work well on a battery.
At 06:56 PM 8/6/2005, Michael Tope wrote:
I just received an Omni 6+ that I bought on Ebay. It appears
to be working nominally, but the microprocessor flakes out
if I drop the input voltage below +13 VDC (measured at the
power input connector with a Fluke 179). The manual claims
it should work down to +12.0V, and in fact my Paragon 585
works down to something like +10.5V before it flakes out.
Is this a common/known problem with the Omni 6+, or is there
perhaps a problem with this particular rig. I'd like to be able
to run it off a battery, but as it stands, I don't think I can.
Thanks,
Mike, W4EF.............................................
|