OK, I stand corrected.
73
Bob, K4TAX
----- Original Message -----
From: "Duane - N9DG" <n9dg@yahoo.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, July 19, 2005 9:25 PM
Subject: Re: [TenTec] ten tec transverters
> Actually the Elecraft XV50, XV144, and XV222 are very much an
> Elecraft design and share next to nothing in direct
> commonality with the DEM transverters. They are however very
> similar in overall circuit design/concept but they use
> completely different circuit boards and an almost completely
> different set of components.
>
> There *is* however a DEM 2M transverter designed to be
> installed inside the QRP K2 and is intended for use as an
> intermediate IF for microwave transverters using a 144 MHz
> IF. That DEM model is the 144-28ECK. It does not have a low
> noise front end device and will only generate 100mW of TX
> power. It also provides essentially 0 dB of gain. As such it
> is not intended to be used directly on air.
>
> There is also a DEM 144-28FRS that is very similar to the
> 144-ECK that is designed to go into the Flex Radio SDR-1000.
> Flex Radio actually offers it as a factory option. It too is
> meant for microwave transverter intermediate IF use.
>
> Duane
> N9DG
>
> --- Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net> wrote:
>
>> The transverters for the Elecraft are actually DEM
>> transverters built
>> specifically for Elecraft.. Look on the DEM site and you
>> will see them listed for the K2.
>>
>> 73
>> Bob, K4TAX
>
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|