While the Tentec transverters are quite good, their performance in terms of
being able to handle high IM environments and operate with a low noise
figure just doesn't happen with them. I have one each of the 6 M and 2 M
models. They work but at the same time the DEM units will blow them away in
high RF prone environments and the noise figure of the DEM is very good to
the point that I hear signals off of the moon on 2M with a single 10 ele
long yagi and no external preamp. The Tentec is no where close to this
performance. Of course the DEM unit is some 2X the cost of the Tentec too.
In my book, performance counts.
73
Bob, K4TAX
----- Original Message -----
From: "ralph" <rhowes@greenapple.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, July 18, 2005 5:01 PM
Subject: Re: [TenTec] ten tec transverters
> Duane:
> Thanks for the comparitive. I thought it was well done for someone, like
> me,
> that has very little knowledge about transverters. Would you care to say
> something about the TenTec 2mtr converters? I was thinking of using one on
> my Omni-C and/or my Corsair II. Anyway I thought it was a well done
> comparitive and easy to understand.
> Thank you,
> Ralph Howes
> W8BVH
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|