Bob,
Yaesu uses the same loop as TT - I think they lifted the idea
from them. My IC-765 was supposed to be a top CW rig, and it ran
semi-decent QSK, but had no ability to run with a QSK amp. Luckily, TT
built the timing loop into their amps, so I could key the amp, and the
amp would key the rig appropriately.
73, Duane
On Tue, 10 Aug 2004 14:32:04 -0000 "Bob Henderson" <bob@cytanet.com.cy>
writes:
>
> ----- Original Message -----
> From: "NJ0IP" <Rick@dj0ip.de>
> To: <tentec@contesting.com>
> Sent: Tuesday, August 10, 2004 6:49 PM
> Subject: RE: [TenTec] G3SJX IC-7800 review
>
>
> > Also, there is no provision for keying a QSK linear (at any
> speed).
> >
> > 73
> > Rick
>
> Are you sure about that Rick? I'm not saying you're wrong but it's
> hard to
> imagine. Or are you refering to a loop circuit which only Ten Tec
> use, so
> far as I know.
>
> Bob, 5B4AGN
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
Duane Calvin, AC5AA
Austin, Texas
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|