Yea but if you had saved $300 and bought a Pegasus then you couldn't have
run the Pegasus in Jupiter mode either and then where would you be? Of
course, you could have taken the $300 and bought a Triton IV which
requires no software and have 2 rigs....
-----Original Message-----
From: "Scott Johnson" <scott@wowpage.com>
To: <tentec@contesting.com>
Date: Wed, 9 Oct 2002 12:48:34 -0400
Subject: [TenTec] Jupiter software
OK, here's a question I can't seem to find the answer to anywhere. The
Jupiter programmer's guide says that there are two modes for
controlling the
radio.
Pegasus emulation mode makes the Jupiter look like a Pegasus -- it uses
the
Pegasus command set and DISABLES the front panel, while Jupiter mode
uses a
separate Jupiter command set and DOES NOT DISABLE the front panel.
Several people have written control software that takes advantage of
Pegasus
mode. Is there no oftware that uses Jupiter mode, so that I can retain
front panel control and display? If I wanted my front panel disabled,
I
would have bought a Pegasus and saved $300. :)
I tried the Jupiter-specific version of PegasusPlus, but it too puts
the
radio in Pegasus mode.
Anyone know about something I missed? Any ideas appreciated.
Scott
--
Scott Johnson (scott@wowpage.com) (s.johnson@klotzdigital.com)
ICQ: 30730876 ICBM: N33 45 50.6 W84 49 31.3 (+- 3dB)
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
.