No, because it works fine when the amp is on line. And also all of the audio
is muted, not even background noise is getting through. I am not using an
amp interface because according to Yaesu it can handle the load put out by
the Henry, which is about 160ma @ 24VDC.
Bob W6TR
----- Original Message -----
From: "Bill Gillenwater" <gillie@pa.net>
To: "Bob Maser" <bmaser@tampabay.rr.com>; "Yaesu Reflector"
<yaesu@contesting.com>
Sent: Wednesday, August 20, 2008 1:42 PM
Subject: Re: [Yaesu] FT1000D with a Problem
> Bob, sounds like it might be a dirty relay in the amp.
>
> 73 Bill K3SV
>
> ----- Original Message -----
> From: "Bob Maser" <bmaser@tampabay.rr.com>
> To: "Yaesu Reflector" <yaesu@contesting.com>
> Sent: Wednesday, August 20, 2008 11:19 AM
> Subject: [Yaesu] FT1000D with a Problem
>
>
>> Hi gang, I am new to this reflector and, since I own a few Yaesu radios,
>> I
>> thought it would be wise to join your group.
>>
>> I have a problem with my FT1000D. I use it mainly on SSB and always PTT.
>> When running the radio barefoot, after making a transmission, the
>> receiver
>> does not "unmute" right away. I can see that the rest of the receiver is
>> working because I see the responding station on my S Meter but no audio
> for
>> a few seconds. The longer I have been transmitting the longer it takes
> for
>> the audio to come back, and when it does come back, it comes on
>> instantly.
>> The strange thing is, when I have the amp on line (Henry 4K Ultra) I
>> don't
>> have the problem.
>>
>> Any suggestions?
>>
>> Tnx,
>> Bob Maser W6TR
>>
>> _______________________________________________
>> Yaesu mailing list
>> Yaesu@contesting.com
>> http://lists.contesting.com/mailman/listinfo/yaesu
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|