I should have said...........
Some of the newer radios with USB can key CW via DTR or RTS on that port
without the need for a hardware interface for keying
On 6/17/2020 8:33 AM, Rich wrote:
You did not mention the radio you are using nor the hardware interface
to key CW.
In WL the Comport for FSK RTTY is selected in RTTYrite. The Comport
for CW keying is selected in "PORTS". The same place you setup your
rig control.
Some of the newer radios with USB can key CW via DTR or RTS on that port.
Rich
On 6/17/2020 7:40 AM, Don AA5AU wrote:
If you believe the MMTTY plug-in will allow it to work again, you
can re-install it again. You can have both the plug-in and XMMT
installed at the same time.
The plug-in is still available on the WriteLog website - third party
page.
Don AA5AU
On Wednesday, June 17, 2020, 06:18:20 AM CDT, Steve Nordahl via
WriteLog <writelog@contesting.com> wrote:
I want to thank you all for getting back to me with your
comments.. Inadvertently, I failed to mention that this did in fact
work in the past.. Let me explain..
I've been using Writelog now for 7 years. I originally set it up and
tied it together using MMTTY and the MMTTY Plug in. During that time
I worked plenty of RTTY & CW contests and was able to send the
preprogrammed messages in Writelog. Flawlessly... So let me say this,
I may have erred in my initial question about Rttywrite doing the
F-key transmission in CW mode. I should have acknowledged that
Writelog, along with using Rttyrite to read & I believe MMTTY's plug
in was handling the F-Key Message Tx'ing. What I was using up until I
think late last year was MMTTY's plug in, At some point I read that
their plug in was no longer supported and I had to convert to use
XMMT. I can't remember when I noticed the break, but by coincidence
when I switched to XMMT the problem with the CW F-keys started. Jim
K0XU mentioned in one comment that it did work. If not taking him out
of context I have to believe that 100 percent. I know.. It worked in
the past so what has changed? Also, this is not about what reader
works best, that's everyones choice.. I agree the Writelog CW reader
works fine and may be better for some, but it scrolls to fast for me.
I like how Rttyrite's highlighting of the calls that Rttyrite does.
To me it's more simplified one click and I can work it... The reader
in Rttyrite works fine and with my old eyes makes things more
productive for me. So, can I go back and still use MMTTY's plug in?
Is this where the break occurred? Do I really need XMMT?
Steve Nordahl, NS3L On Tuesday, June 16, 2020, 10:41:05 AM EDT,
Steve Nordahl <ns3l@yahoo.com> wrote:
Hi all.. I have a ongoing problem.. When using Rttyrite in Writelog, it works fine in FSK RTTY. It sends and hears RTTY no problem. The F-keys are also sending no problem.
My issue is when I go to do CW. Rttyrite in Sound Board AFSK and CW mode receives fine. However, if I hit any of the programmed F-keys nothing happens..!! It does not key the rig..
Has anyone else had this occur? How do I get Rttyrite to send CW messages via the F-keys?
Equipment is as follows. Win 10 laptop, Icom IC-7000, microHam MK II, Writelog V12.50H
Hope someone can unravel this for me..
Steve NS3L
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|