WriteLog
[Top] [All Lists]

Re: [WriteLog] Can't get Rttyrite CW to send CW via F-Key's

To: writelog@contesting.com
Subject: Re: [WriteLog] Can't get Rttyrite CW to send CW via F-Key's
From: Rich <rwnewbould@comcast.net>
Date: Wed, 17 Jun 2020 08:33:48 -0400
List-post: <mailto:writelog@contesting.com>
You did not mention the radio you are using nor the hardware interface to key CW.

In WL the Comport for FSK  RTTY is selected in RTTYrite.  The Comport for CW keying is selected in "PORTS".  The same place you setup your rig control.

Some of the newer radios with USB can key CW via DTR or RTS on that port.

Rich

On 6/17/2020 7:40 AM, Don AA5AU wrote:
  If you believe the MMTTY plug-in will allow it to work again, you can 
re-install it again. You can have both the plug-in and XMMT installed at the 
same time.
The plug-in is still available on the WriteLog website - third party page.
Don AA5AU
     On Wednesday, June 17, 2020, 06:18:20 AM CDT, Steve Nordahl via WriteLog 
<writelog@contesting.com> wrote:
I want to thank you all for getting back to me with your comments.. Inadvertently, I failed to mention that this did in fact work in the past.. Let me explain..

I've been using Writelog now for 7 years. I originally set it up and tied it together 
using MMTTY and the MMTTY Plug in. During that time I worked plenty of RTTY & CW 
contests and was able to send the preprogrammed messages in Writelog. Flawlessly... So 
let me say this, I may have erred in my initial question about Rttywrite doing the 
F-key transmission in CW mode. I should have acknowledged that Writelog, along with 
using Rttyrite to read & I believe MMTTY's plug in was handling the F-Key Message 
Tx'ing. What I was using up until I think late last year was MMTTY's plug in, At some 
point I read that their plug in was no longer supported and I had to convert to use 
XMMT. I can't remember when I noticed the break, but by coincidence when I switched to 
XMMT the problem with the CW F-keys started. Jim K0XU mentioned in one comment that it 
did work. If not taking him out of context I have to believe that 100 percent. I know.. 
It worked in the past so what has changed? Also, this is not about what reader works 
best, that's everyones choice.. I agree the Writelog CW reader works fine and may be 
better for some, but it scrolls to fast for me. I like how Rttyrite's highlighting of 
the calls that Rttyrite does. To me it's more simplified one click and I can work it... 
The reader in Rttyrite works fine and with my old eyes makes things more productive for 
me. So, can I go back and still use MMTTY's plug in? Is this where the break occurred? 
Do I really need XMMT?

Steve Nordahl, NS3L    On Tuesday, June 16, 2020, 10:41:05 AM EDT, Steve Nordahl 
<ns3l@yahoo.com> wrote:
Hi all.. I have a ongoing problem.. When using Rttyrite in Writelog, it works fine in FSK RTTY. It sends and hears RTTY no problem. The F-keys are also sending no problem.

My issue is when I go to do CW. Rttyrite in Sound Board AFSK and CW mode receives fine. However, if I hit any of the programmed F-keys nothing happens..!! It does not key the rig..

Has anyone else had this occur? How do I get Rttyrite to send CW messages via the F-keys?

Equipment is as follows. Win 10 laptop, Icom IC-7000, microHam MK II, Writelog V12.50H

Hope someone can unravel this for me..

Steve NS3L
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/
<Prev in Thread] Current Thread [Next in Thread>