My Setup: Writelog 12.35c and MicroHAM, Microkeyer
Have Comm10 identified and working for CW K1EL Keyer in uRouter. I was
able to send CW from uRouter.
In Writelog 12.35c, I selected PORTS and set Comm10 for CW and then
identify K1EL Winkey as the CW Keying Interface. When I tap APPLY and
then OK I am getting a "Can't open port for Winkey" error. This
implies that something else is using Comm10, but I am not aware of
anything that is using Comm10. So I shutdown to power off with the
computer thinking that this would release Comm10--no luck!
BTW this configuration with Comm10, uRouter and Writelog v11.29 worked.
Any help here?
Jim/KC4HW
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|