I have found that if a USB/Serial Adapter works for RigControl in HRD but not
Writelog, you can go into the Writelog.ini file and modifiy the comport setting.
[RIGS]
Com4:=9600,n,8,2 <=== Remove the '2' but leave the comma. Sometimes just
changing the 2 to a 1 will work. Doesn't cost anything to try.
I got a new computer, Windows7 and my old 4 comport serial board would not work
at all. So I bought a USB/Serial adapter off of Amazon.
This has 4 comports and uses the FTDI chip. As soon as I plugged it in, it
worked. Windows found the drivers. It is running my CW, RigControl and
RotorControl. Since the motherboard had one comport, I am using it for FSK.
Here is a link to the adapter:
http://www.amazon.com/dp/B004ETDC8K/ref=pe_175190_21431760_cs_sce_dp_1 ;
Joe K0BX
Stop the insanity!
Please do not add me to any distribution lists (Joke, Stories or Junk) without
my permission.
________________________________
From: Tom Shelton <gl1800winger@verizon.net>
To: Vince <rradiohham232@sbcglobal.net>; writelog-bounces@contesting.com
Cc: Writelog Reflector <writelog@contesting.com>
Sent: Wed, February 15, 2012 8:18:43 PM
Subject: Re: [WriteLog] CAT control on a Kenwood TS-870
I had the same problem with my Kenwood (TS-2000) when I first ran WriteLog. The
USB/Serial adapter I was using worked well with most other programs, including
HRD.
Yet, it was that adapter that was the problem. If you get one with the FTDI
chip
set, you won't have any problems.
Go onto Amazon.com and do a search for FTDI usb serial, and a bunch will pop
up.
Make sure you look at the product description and that it specifically says
FTDI. Then you can buy from amazon or look around on-line for a better price.
After I put the new adapter in, some of the other programs (like DX Lab Suite)
have started to work better than before.
Tom, AB3IC
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|