Still no luck with the PTT being enabled on startup.
I don't see a configuration problem in Router. I do not have the CAT port
defined as the PTT port in Router. COM1 is PTT and COM2 is CAT. This has
been unchanged since I acquired the MK II.
I went into the writelog.ini file and in the [RIGS] section added the
following lines:
COM1_RTS_INIT=0
COM1_DTR_INIT=0
That didn't work. Then I tried:
COM2_RTS_INIT=0
COM2_DTR_INIT=0
That didn't work either.
According to the help manual this is supposed to cause WL to initialize
these lines off, but when I start WL I still get the error message about the
sound card being in use and then when WL starts the radio goes into TX and
cannot stopped. If I set the mode on the radio to CW I get the error
message about the sound board, but when I clear it the radio comes up in CW
ok and I can send CW memory messages normally.
So the problem is how WL starts when in SSB, but if the initialize commands
I used above don't work what do I do next? I can't understand what I need
to do to make this work again for SSB.
73,
Gary AL9A
----- Original Message -----
From: "Joe Subich, W4TV" <lists@subich.com>
To: <writelog@contesting.com>; "Gary AL9A" <al9a@mtaonline.net>
Sent: July 23, 2010 7:42 AM
Subject: Re: [WriteLog] WriteLog - MK II statup problem
>
> You have a configuration mismatch between WriteLog and Router ...
> Writelog is probably asserting RTS on the CAT port while you have
> PTT defined on that port in Router. You will either need to
> disable PTT on the CAT port in Router or use "RTS/DTR override"
> in the [RIGS] section of writelog.ini to suppress initialization
> of DTR/RTS on the radio port. See [RIGS] in the WriteLog help
> file.
>
> 73,
>
> ... Joe, W4TV
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|