WriteLog
[Top] [All Lists]

Re: [WriteLog] First time user

To: "Jim Brown" <jim@audiosystemsgroup.com>,<writelog@contesting.com>, <N9NUN@aol.com>
Subject: Re: [WriteLog] First time user
From: "Ric Plummer" <ricp@charter.net>
Reply-to: Ric Plummer <ricp@alum.wpi.edu>
Date: Sun, 23 Nov 2003 15:20:10 -0000
List-post: <mailto:writelog@contesting.com>
Also, if you use the Writelog Mixer control,
Start/Programs/Writelog v10/Sound Board Mixer Control
you will have the controls you need all on one panel,
no switching between record and playback
Ric KV1W

----- Original Message ----- 
From: "Jim Brown" <jim@audiosystemsgroup.com>
To: <writelog@contesting.com>; <N9NUN@aol.com>
Sent: Sunday, November 23, 2003 15:05
Subject: Re: [WriteLog] First time user


> You may need more level. This is controlled by the mixer adjustments in
> Windows. The Windows mixer has two screens -- one for playback and one
> for record. This selected on most sound card mixers with the Options
> menu. You are looking for the Record settings, and the Line Input. 
> 
> Jim
> 
>  --Original Message Text---
> From: N9NUN@aol.com
> Date: Sun, 23 Nov 2003 07:44:30 EST
> 
> Feed receive audio to your sound card, (and set the sound card's input
> mixer to accept it), then tell WriteLog to start the CW Reader! There
> are some setup choices for the range of audio frequencies and speeds to
> copy, but the defaults are a good starting point. 
> 
> Hello,
> Thank you very much for replying back.  I have the cable connected from
> the back of the rig (AF out) to the sound card.  If I open the sound
> card and it test it will receive the cw and playback the sounds.  Once
> I go back to WriteLog and open up the CW Decoder nothing happens.  If I
> try to receive thru RTTYrite I receive a mess of letters that don't
> make any sense any they come up even with the rig OFF.  I'm not sure
> where this is getting it from but no signal from the radio.  I'm sure
> somewhere I messed up on configuration.  
>  
> Mike
> 
> 
> In a message dated 11/22/2003 8:58:20 AM Central Standard Time,
> jim@audiosystemsgroup.com writes:
> Feed receive audio to your sound card, (and set the sound card's input
> mixer to accept it), then tell WriteLog to start the CW Reader! There
> are some setup choices for the range of audio frequencies and speeds to
> copy, but the defaults are a good starting point. 
> 
> Jim K9YC
> 
> On Sat, 22 Nov 2003 07:59:02 EST, N9NUN@aol.com wrote:
> 
> >What does it take to receive cw from the rig thru Writelog.  
> 
> 
> 
> 
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>