You may need more level. This is controlled by the mixer adjustments in
Windows. The Windows mixer has two screens -- one for playback and one
for record. This selected on most sound card mixers with the Options
menu. You are looking for the Record settings, and the Line Input.
Jim
--Original Message Text---
From: N9NUN@aol.com
Date: Sun, 23 Nov 2003 07:44:30 EST
Feed receive audio to your sound card, (and set the sound card's input
mixer to accept it), then tell WriteLog to start the CW Reader! There
are some setup choices for the range of audio frequencies and speeds to
copy, but the defaults are a good starting point.
Hello,
Thank you very much for replying back. I have the cable connected from
the back of the rig (AF out) to the sound card. If I open the sound
card and it test it will receive the cw and playback the sounds. Once
I go back to WriteLog and open up the CW Decoder nothing happens. If I
try to receive thru RTTYrite I receive a mess of letters that don't
make any sense any they come up even with the rig OFF. I'm not sure
where this is getting it from but no signal from the radio. I'm sure
somewhere I messed up on configuration.
Mike
In a message dated 11/22/2003 8:58:20 AM Central Standard Time,
jim@audiosystemsgroup.com writes:
Feed receive audio to your sound card, (and set the sound card's input
mixer to accept it), then tell WriteLog to start the CW Reader! There
are some setup choices for the range of audio frequencies and speeds to
copy, but the defaults are a good starting point.
Jim K9YC
On Sat, 22 Nov 2003 07:59:02 EST, N9NUN@aol.com wrote:
>What does it take to receive cw from the rig thru Writelog.
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|