I sent a different reply to Gary directly. After reading this one, I'm not
sure Bob is correct. Gary was asking about PTT. In MMTTY stand-alone,
PTT (and FSK) are controlled on the same COM port as set in the
Setup MMTTY screen on the TX tab.
However, in the MMTTY Plug-in, there is no PTT port selection on the TX
tab. Instead, PTT (and FSK) are controlled by the Port menu selection in the
Rttyrite window. Of course, you don't need FSK is you are running AFSK,
but PTT should still be controlled by the COM port selection under the Port
menu in the Rttyrite window.
I think I'm right. I control PTT through radio control, but I can test it with
my PTT interface which I still have but no longer use if anyone needs to me to.
73, Don AA5AU
----- Original Message -----
From: "Robert McGwier" <rwmcgwier@comcast.net>
To: "Writelog" <writelog@contesting.com>
Sent: Saturday, July 12, 2003 10:23 AM
Subject: RE: [WriteLog] WriteLog & MMTTY PTT Problem
> You need to go into Writelog set for Ports
> and TURN IT OFF on the FSK keying port.
> MMTTY does this directly and Writelog's setting
> interferes. If you are using MMTTY and are
> doing RTTY only, this is great. Where it
> becomes a problem is if you want to do PSK31
> or PSK63 in addition to RTTY. THen you have
> to unload MMTTY and choose Writelog's PSK program.
> I am hoping this gets resolved to our benefit
> soon. I have access to the source code for PSKCORE.dll
> but of course, no such access to MMTTY.exe. A way
> that this could be accomplished would be to use
> Winwarbler as the interface to both MMTTY and
> PSKCORE since it talks to both. Dave Bernstein
> (http://www.qsl.net/dxlab ) would accomodate
> us in short order if I knew how to get Winwarbler
> to talk to Writelog.
>
> Bob
> N4HY
>
>
>
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com]On Behalf Of Gary Kohtala
> Sent: Saturday, July 12, 2003 05:20
> To: writeLog@contesting.com
> Subject: [WriteLog] WriteLog & MMTTY PTT Problem
>
>
> I'm running the latest release of WriteLog and have
> also
> downloaded the recommended MMTTY engine for use with
> it.
> Unfortunately, MMTTY fails to access the serial port
> when run from WriteLog. I can exit WriteLog and MMTTY
> operates perfectly in stand-alone fasion. I thought I
> had the port(s) set up correctly in WriteLog, but for
> whatever reason, I'm unable to do anything with MTTY
> from there. Can someone please point me in the correct
> direction, and maybe show me the err of my ways?
> Thanks
> in advance....
>
> 73,
>
> Gary, W7NTF
>
>
>
> __________________________________
> Do you Yahoo!?
> SBC Yahoo! DSL - Now only $29.95 per month!
> http://sbc.yahoo.com
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
|