Wayne,
I spoke too soon. I'm going to swap the rig from com 3 to com 2. Com 3 and
4 are on the Byterunner card--perhaps something is happening there. I tried
the Tentec Omni VI setting again and at least it works this time...
Tom
----- Original Message -----
From: Tom Branch <tom.branch@qth.com>
To: Wayne F. King <wfking@worldnet.att.net>
Cc: Writelog Reflector <Writelog@contesting.com>
Sent: Tuesday, November 21, 2000 7:53 PM
Subject: Re: [WriteLog] Tentec Omni 6
>
> Wayne,
>
> I set the port setup flag to "sync". This appears to fix the problem. I
> don't understand why though. From the Writelog help file:
>
> quote
>
> Com PTT:
>
> The purpose of this setting is to accommodate rigs that have
synchronization
> restrictions between being polled for their frequency and accepting PTT
> commands. This setting only has an effect if the rig supports PTT commands
> over its serial port. Most Kenwood and Yaesu do. Most Icom do not.
>
> end quote
>
> Guess I should just be happy it works...
>
> TU es 73 de Tom, K4NR
>
>
> ----- Original Message -----
> From: Wayne F. King <wfking@worldnet.att.net>
> To: Tom Branch <tom.branch@qth.com>
> Sent: Tuesday, November 21, 2000 3:51 AM
> Subject: Re: [WriteLog] Tentec Omni 6
>
>
> > My OMNI VI works fine with WL. Here's my setup in WL ports:
> > com3, 9600 baud, poll checked and sync. I have had no problems. I hope
you
> get
> > your Omni VI working with WL.
>
>
>
> --
> WWW: http://www.writelog.com/
> Submissions: writelog@contesting.com
> Administrative requests: writelog-REQUEST@contesting.com
> Problems: owner-writelog@contesting.com
>
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|