Writelog V10.X (not sure about prior versions) has configuration
settings for both the Omni V and Omni VI. Use the one that
applies. I run an Omni 6+ and it works great.
---
73, Rich - W3ZJ
> -----Original Message-----
> From: owner-writelog@contesting.com
> [mailto:owner-writelog@contesting.com]On Behalf Of Tom Branch
> Sent: Tuesday, November 21, 2000 0:35 AM
> To: Writelog Reflector
> Subject: [WriteLog] Tentec Omni 6
>
>
>
> Greetings,
>
> I've been running Writelog for some time but just
> decided to add rig
> control. I have a Tentec Omni 6 (Version 2.0
> firmware). I put the rig on
> com 3 and selected the Omni 6. It was bad! I had to
> do a hard reset on the
> radio to get it back online. I used the Icom 735
> (Tentec says the Omni uses
> the Icom instruction set). It does work, but when
> tuning the rig with the
> VFO it will jump 100 KHz from time to time. When
> tuning along and the band
> gets quiet on 20 phone you can look and see you are at
> 14100 rather than
> 14200! I've tried the other Icom and Tentec rigs--any ideas?
>
> 73 de Tom, K4NR
>
>
>
> --
> WWW: http://www.writelog.com/
> Submissions: writelog@contesting.com
> Administrative requests: writelog-REQUEST@contesting.com
> Problems: owner-writelog@contesting.com
>
>
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|