VHFcontesting
[Top] [All Lists]

Re: [VHFcontesting] Setting up TE RF amp for use with a sequencer.

To: nosigma@aol.com
Subject: Re: [VHFcontesting] Setting up TE RF amp for use with a sequencer.
From: KC2TN <kc2tn@comcast.net>
Date: Sun, 15 Dec 2019 21:49:03 -0500
List-post: <mailto:vhfcontesting@contesting.com>
I’d be interested in what they tell you regarding the pin 5-6 jumper. 

I’m looking to disable this as well. 

Joe - KC2TN 

> On Dec 15, 2019, at 6:30 PM, John Young via VHFcontesting 
> <vhfcontesting@contesting.com> wrote:
> 
> 
> Taking pin 2 to ground turns on the PA with 5 and 6 still internally 
> connected.  
> 
> However with 5 and 6 internally connected the rf sensing is still enabled 
> which defeats part of the purpose of the sequencer.  The amplifier can turn 
> on if RF gets to it even if the PTT ground to rf amp lead from the sequencer 
> is not grounded.  
> 
> I have had my 991A on 6m buzz my 1.25m amp, same thing happened with the W4IY 
> Elecraft on 6m in september.  If I had been using a hard keyed pre amp on 
> 1.25m it would have been fried.
> 
> I opened up the amp and there is no obvious sign of the pin 5-6 internal 
> shorting wire.  Maybe you have to cut a trace now?
> 
> 
> Calling TE Tomorrow.
> 
> 73
> John
> KM4KMU 
> On Sunday, December 15, 2019 John Young via VHFcontesting <nosigma@aol.com> 
> wrote:
> 
> The TE manual gives some simple instruction for hard keying the amplifier but 
> out an abundance of caution I want to verify my understanding of them before 
> I start cutting wires and adding relays.
> 
> The DEMI sequencer gives a sequenced PTT ground to enable the amplifier.  The 
> TE  instructions are to cut the internal  shorting wire between pins 5 & 6 
> and then connect the PTT ground to pin 2.
> 
> To enable the RF amplifier the TE instructions are:  1) Connect pin 5 & 6 
> then 2) connect pin 2 to PTT ground.
> 
> My interpretation of these instruction are:
> I need to use the PTT ground to close a relay that connects pins 5 & 6 and 
> then use an output from this relay to close another relay that connects the 
> PTT ground to pin 2 on the amplifier.
> 
> Is this correct?
> Is there a better way?
> 
> 73
> John
> KM4KMU 
> 
> 
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting

_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
<Prev in Thread] Current Thread [Next in Thread>