Is it possible to change the firmware? Mike
-----Original Message-----
From: Hal Dale <wb4aeg@gmail.com>
To: Donald M. Ross <N12614@aol.com>
Cc: mikflathead <mikflathead@aol.com>; vhfcontesting@contesting.com
<VHFcontesting@contesting.com>
Sent: Fri, Mar 3, 2017 7:43 pm
Subject: Re: [VHFcontesting] Yaesu 736R question
Ur firmware is wrong...
On Fri, Mar 3, 2017 at 7:39 PM, Donald M. Ross via VHFcontesting
<vhfcontesting@contesting.com> wrote:
Because those are the European 2m and 70cm bands?
-----Original Message-----
From: VHFcontesting [mailto:vhfcontesting-bounces@contesting.com] On Behalf
Of mike repinski via VHFcontesting
Sent: Friday, 3 March, 2017 18:36
To: vhfcontesting@contesting.com
Subject: [VHFcontesting] Yaesu 736R question
I am trying to fix a 736. The CPU board was replaced. The board was
purchased off Ebay. The board came from Europe. The radio will cover 144-146
and 430-440. The diodes are correct on the 2 meter and 430 boards. I am not
sure why it is only covering these frequencies? Any insight. Thanks Mike
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|