James Duffey wrote:
> Another technique is to use a half wavelength or integral multiple of
> half wavelengths of the 75 Ohm coax. A half wavelength transmission
> line will repeat the impedance at one end to the other. So if you
> connect 75 Ohm coax to a 50 Ohm load and feed it with a 50 Ohm
> generator, the generator will see a 50 Ohm match.
>
> Also, RG-6 designed for TV and video use is widely available, low
> loss, and cheap. One can use these techniques to effectively utilize
> it. - Duffey
>
>
> --
> KK6MC
> James Duffey
> Cedar Crest NM
>
>
>
>
>
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting
>
One problem with this technique is that as the feedline becomes many
half waves long, the bandwidth over which the match is good gets pretty
narrow. One of my friends used this technique with about 350' of CATV
hardline to feed a TH6 tribander and on 10 meters (where the feedline is
approximately 25 half waves long) the match was only good for a couple
hundred KHz. He put Amidon 50:75 un-uns on both ends and the match
started to look like what the HyGain manual claimed.
And it's necessary to be pretty close to right on to make this work
right. Here at K8CC, I had an 80 meter four-square phased array fed
with a random length of CATV hardline estimated to be around 270' long.
The SWR showed 1:1 across the band when measured at the Comtek phasing
box, and it was 1:1 at 3800 KHz but 2:1 at 3500 KHz. Again, a pair of
Amidon 1:1 un-uns made the SWR in the shack look like the SWR at the
load. But keep in mind, this was at 3.5 MHz where the line wasn't all
that many half-wavelengths.
I would think that on VHF it wouldn't be too hard to wind up with a
feedline many half waves long. Even then, it might be possible to use
this technique but you might have to carefully prune the feedline to
optimize where the best match is centered.
I"m not saying it can't be made to work, but there are issues in play
with this approach.
73, Dave/K8CC
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|