I've used that stuff quite a lot, although I usually put a layer of
teflon plumbing tape over the connector itself first in order to make
sure I can remove everything in the future. Hot glue isn't always easy
to remove. I just make sure that the heat shrink tubing extends an inch
or two past the teflon tape for the seal.
I buy the adhesive lined heat shrink tubing on eBay ... there is tons of
it there.
Dave AB7E
On 4/18/2025 3:12 PM, Brian Beezley wrote:
Has anyone tried this method?:
https://tinyurl.com/mr3n2htx
Brian
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|