The 4.3-10 mini-DIN connector that KG2V referred to is not much larger than
a PL-259/SO-259. It has a M20 (~Ø7/8) thread and a SO-239 has a Ø5/8
thread. I considered using them and even purchased a few but never used
them.
John KK9A
Jim K9YC wrote:
On 7/25/2022 11:26 AM, Charles Gallo (KG2V) wrote:
> I'd say the way to actually go, if we are going to push for a change is
> probably 4.3/10 DIN connectors - go where the RF industry has gone for
> 1/2 foam coax
Who wants to push for a change? Those DINs are BIG so burn lots of
panel real estate, and expensive. Their broad use is in commercial
systems that run at high UHF. At 2M and below, I could care less. I'm an
ENGINEER who understands transmission lines, not a lab rat who doesn't.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|