Since we are chatting about guy termination. Is it Ok to use a 3/8” Big Grip
on a single guy anchor rod without using a shackle or thimble? It was
suggested that I needed a thimble at the rod end, but that’s not even possible
without an intermediate shackle of some sort.
Ty K3MM
Sent from the all new AOL app for iOS
On Tuesday, May 3, 2022, 11:47 AM, john@kk9a.com wrote:
A Big-Grip would go though the eye of the turnbuckle on the tower side
regardless if an equalizing plate was used or not. Connecting the
turnbuckle to the anchor rod may be an issue, depending on the jaw opening.
This is another reason to purchase the proper plates.
John KK9A
Steve Maki K8LX wrote:
Good point Tim.
But he said nothing about preforms.
I was assuming the anchor rods were the kind with the 'fist" ends, which
are made to have multiple wires wrapped through them. I thought he was
going to use cable clamps or compression sleeves, not big grips. That
sort of install is fine for a 60' tower.
But yes, you know what they say about assumptions...
-Steve K8LX
On 5/3/2022 10:34 AM, Tim Duffy wrote:
> Do you think it is safe to have two preforms with proper guy wire
galvanized
> thimbles (connected to guy wires via turnbuckles) at the end of a single
> anchor rod? Without EQ plates?
>
> Why is no one suggesting asking Rohn what they recommend?
>
> There was a tower a few years ago that fell - because the wrong thimbles
> were used and it caused the preform to fail.
>
> I would never climb a tower that did not have the proper Rohn
installation.
>
> 73
> Tim K3LR
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|