Hello,
I am assembling the 8 pins of the 9 pin cable connector for a "new to me"
Hygain Tailtwister. I know I'll only get one shot at this unless I have a
pin extraction tool. It is the Amp 09 StdSx Plug with female pins. I have
Google searched assembly instructions with no luck.
There is a double set of "wings" for holding the wire. Do they need to go
all the way into the back of the connector? If so, it looks like I will
need to trim them as they are too long to fold over the wire.
--
Thank you!
David Needham, AA4VT
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|