Hi Bill.
I'm going to go out on a limb and guess you're reading some literature
on this tower.
If you're of a mind to, why not make a copy of it and upload it to the
files area of the Crank Up, Tilt Over Towers email list at
https://groups.io/g/CrankupTiltoverTowers so that this information won't
be permanently lost, one day?
73,
Jon Pearl - W4ABC
On 11/4/2020 2:49 PM, Bill Winkis (Mindspring) wrote:
I can find no reference to a THS-471 ... there is a HS-471, it's a 4
section tower, crankup, with area measurement of each section at
22",.....19 3/8".....16 1/2" ....and the top section at 13 7/8
inches...these measurement are one side of the triangle measured from
the inside to inside on the pipes.
extended height is 71" and nested at 21 1/2 feet..weight is 575
pounds...It's a guyed tower, the guy kit is 120 pounds...all tower
braces/struts are horizontal..no angles braces....
The cost of the guys $390.00..tower cost was $1177.00..Guyed the tower
would handle 16 sqft ....
The 106 foot version of the HS series had a bottom section of 27 5/8
inches...
Hope this helps..
Bill ... KC4PE
http://www.kc4pe.com/amateurshack.htm
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|