I believe it means your NE/SW elements should align to EU if that's
where you want to point. In other words, point the corners towards where
you want your signal. That's how I had mine set up and it worked per the
book.
Les W2LK
On 10/18/2020 3:24 PM, kq2m@kq2m.com wrote:
Hi Alan,
I saw that too but it doesn’t answer my questions. "Radiation across
the diagonals" is a vague and unhelpful statement. It doesn’t address
in what directions the elements should placed nor which elements are
effectively being phased and radiating to produce the NE direction
radiation.
73
Bob KQ2M
-----Original Message----- From: Alan Swinger
Sent: Sunday, October 18, 2020 2:55 PM
To: kq2m@kq2m.com ; towertalk@contesting.com
Subject: Re: [TowerTalk] 4 square question
Per my DX Eng Guide used to construct my 40M 4 Sq and in daily use,
radiation is on the diagonals . .. not broadside. - Alan K9MBQ
-----Original Message-----
From: kq2m@kq2m.com
Sent: Oct 18, 2020 2:49 PM
To: towertalk@contesting.com
Subject: [TowerTalk] 4 square question
Hi,
I will be rebuilding several 4-squares this season as well as
restringing them in different trees due to Tornado damage (loss or
destruction of many trees at my qth) during Tropical Storm Isaias on
August 4th. I have a few questions for which I would appreciate your
guidance....
1) If I recall correctly, for purposes of focusing on Europe, ideally
I would want to put the 4 elements in a box formation in the NE, SE,
SW and NW directions relative to the middle of the array. Is that
correct?
2) In the 4-square when I select the controller direction NE, I am
effectively radiating broadside NE from the NW and SE elements. Is
that correct?
3) In the past I had the bottom of the 4-square elements soldered to
center conductor of the pin of an SO239 with the radials attached to
each of the SO239 screw holes, with the coax connector for the
phasing line screwed onto the SO239. (The choke was located below
the PL259 on the phasing line) This worked well but I am trying to
improve the design.
If I were to terminate the bottom of the 4-square element by twisting
it through and around one hole of the porcelain insulator and
soldering it there, would I still be able to then solder a small wire
from that connection to the center conductor pin of a SO239 with the
radials attached to the SO239 screw holes as before? My idea being
that I can do that then I can use a piece of twine through the
remaining porcelain insulator hole taped to the coax to provide
additional physical support for the coax and radials – which will be
helpful during ice storms.
I would appreciate any thoughts and suggestions and possible
improvements on this design.
Tnx & 73
Bob, KQ2M
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|