You need two sheaves for the leverage required to raise that tower.
Don't know where to get the exact replacement but there are a few places
that have similar items if you search around.
Les W2LK
On 10/14/2020 9:28 PM, Mike & Becca Krzystyniak wrote:
Greetings,
Without going to UST, I have been trying to locate a replacement
pulley/sheave for my HDX-555 tower. This is sheave that the raising cable
uses. There are two slots but there was only one sheave. Can someone
confirm whether the tower uses 1 or 2 sheaves, and also a lead on where to
buy other than UST?
Spec: 3.5" OD, 1/2 inch thick with 1/2" bolt hole. It is aluminum with what
appears to be a pressed in bearing (which has siezed).
Thanks for any info.
73 Mike K9MK
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|