Towertalk
[Top] [All Lists]

[TowerTalk] HDX-555 raising fixture sheave(s) ??

To: <towertalk@contesting.com>
Subject: [TowerTalk] HDX-555 raising fixture sheave(s) ??
From: "Mike & Becca Krzystyniak" <k9mk@flash.net>
Date: Wed, 14 Oct 2020 20:28:50 -0500
List-post: <mailto:towertalk@contesting.com>
Greetings,

   Without going to UST, I have been trying to locate a replacement
pulley/sheave for my HDX-555 tower.  This is sheave that the raising cable
uses. There are two slots but there was only one sheave.  Can someone
confirm whether the tower uses 1 or 2 sheaves, and also a lead on where to
buy other than UST?

Spec: 3.5" OD, 1/2 inch thick with 1/2" bolt hole.  It is aluminum with what
appears to be a pressed in bearing (which has siezed).

Thanks for any info.

73  Mike  K9MK





_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>