Martin makes them, McMaster no brand was by them a while back. Also
sometimes call tappet wrenches. Hard to find in < 7/16" but most
ignition sets are thin enough. Amazon has Craftsman and assorted
Chinese sets.
Grant KZ1W
On 7/21/2020 14:03, K9MA wrote:
On 7/21/2020 2:49 PM, jimlux wrote:
Or 4 nuts - nut1 wire nut2 pvc nut3 wire nut4
The preload between nut1 and nut2 and the preload between nut3 and
nut4 are what make the contact. Takes two wrenches to get it tight
enough.
Speaking of which, it's hard to find wrenches thin enough to lock two
6-32 or 8-32 nuts together. I have one old, cheap, Craftsman set that
works, but sooner or later I'm going to lose one of those up on the
tower. All the small wrench sets ("Ignition Wrenches") available seem to
be too thick. Short of grinding them down, does anyone know where to get
thin ones in SAE sizes?
73,
Scott K9MA
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|