Towertalk
[Top] [All Lists]

Re: [TowerTalk] HyGain HDR300 removal stalled due to stuck setscrew

To: James Wolf <jbwolf@comcast.net>
Subject: Re: [TowerTalk] HyGain HDR300 removal stalled due to stuck setscrew
From: Al N6TA <al.n6ta@gmail.com>
Date: Thu, 29 Aug 2019 13:15:18 -0700
List-post: <mailto:towertalk@contesting.com>
Good suggestions received from this 'team' of experienced problem solvers.
Aero Kroil is $20 at the auto parts store.  I bought PB Blaster for 7 first
to see if it work.  After 5 minutes, nope so will try again after another
24 hours of waiting.
Going to get a new and quality hex key and maybe two for one to cut off and
tap on
Have a MAPS gas torch and sounds like it is another good idea though I am
new to actually heating to loosen.
Got a suggestion to use a fine powder (grinding compound?) that can provide
added contact of tool to fastener that may help.  Easy to try.
If these do not work, the special drill bit and maybe the EZ out will be
tried.

With all the great ideas, I am sure it is going to give up before I do.

Thanks very much.
Al
N6TA


On Thu, Aug 29, 2019 at 10:02 AM James Wolf <jbwolf@comcast.net> wrote:

> To help break loose the setscrew, put in an allen wrench and smack with it
> a
> hammer to  break it loose.  You likely can't do it well with an angled
> wrench, so cut the end off so you can tap it hard.  Hopefully that will
> loosen the threads.   PB blaster soaked a few days will help too as just a
> few minutes may not be enough.  If you have to try to drill It out, get a
> left turning drill, it just may come out with the drill.
>
> Jim - KR9U
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>