Towertalk
[Top] [All Lists]

Re: [TowerTalk] Radials vs. cows

To: jim@audiosystemsgroup.com, towertalk@contesting.com
Subject: Re: [TowerTalk] Radials vs. cows
From: Richard Thorne <rthorne@rthorne.net>
Date: Tue, 30 Jul 2019 18:58:03 -0500
List-post: <mailto:towertalk@contesting.com>
If its a low band vertical check out the FCP.

https://k2av.com/

Rich - N5ZC

On 7/30/2019 3:57 PM, Jim Brown wrote:
You didn't say for what band. If for 160 or 80, I'd go with elevated radials if practical. The good advice I've gotten (from N6BT)  is that 18 ft is sort of a minimum height for 160, so half that for 80. Also, of course, per N6LF, eight is better than four, because it maximizes the uniformity of current distribution on the radials. My elevated radials for 160 worked a lot better after I raised them from about 6 ft to about 18 ft.

73, Jim K9YC

On 7/30/2019 12:14 PM, Gary Johnson wrote:
I’m about to put in a radial field but the area is infested with Angus. Terrain is in its natural state, never graded, planted or anything, just coarse grass and weeds and pretty rocky and uneven. I was hoping to use lawn staples (lots of them) as they seem to have a very good grip in this soil.

My concern is that the cows will snag the wires or pull them up while grazing. Then I’m stuck trying to shallow-bury everything... ugh.  Anyone have any experience or advice on cows vs. radials?

Gary NA6O
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>